.jpg)
“If you have ever asked the question whether trimmings are all the same, we have a simple answer to give you: absolutely not! What does this involve? Obviously, it is not possible to handle them always and in any case in the same way. Therefore, even the suction systems cannot be all similar or standardized. This is why New Aerodinamica deals with every job in this way: evaluating first of all carefully the production specifications of each single machine and the materials, deciding only after this analysis the suitable equipment to be used. Three key points to consider in order to make the right decision: efficiency, energy consumption and noise”
By reviewing the sectors in which New Aerodinamica operates we find a first example in the field of labels, plastic and extensible films where for over 20 years has been used the injector system, that now is ultra-performing. Thanks to these improvements, unthinkable results have been achieved such as sucking on cutting machines at 1,200 m/min and transporting this plastic-adhesive material for over 150 m. An essential specification: thanks to the continuous transport system signed by New Aerodinamica, no material cuts are made, no further powders and electrostatic charges are generated, no adjustment is required depending on the type of product, noise doesn’t increase in the area of operation and no maintenance is required.
“These unique results have allowed us to gain more and more consensus and, where sometimes there was an initial skepticism, then prevailed the belief in the efficiency of our systems. So, our strength and our drive to do better is precisely born from this desire to amaze and dissolve all skepticism. And so, slowly, all those who have tried our system, replaced all the other types of systems. All this gained experience has also allowed us not to stop in the innovation process, leading to the creation of dedicated systems, different for every machine, avoiding the centralized system, which involves the connection of several machines, to a single fan with cutting system. This allows an enormous energy saving, a subdivision of the aspirated materials and an optimization of the workflows”
concludes Radaelli.
Another example can be found in pylons or self-supporting structures, necessary to support the equipment, made with dimensioned profiles, calculated based on their location and the seismicity of the area on which they are placed, the effects of wind and snow loads. The evaluation of all this therefore allows to prepare a specific certification.
Last but not least, accesses in safety at high elevations are also made, with maritime staircase, side walkways with parapets and gates with automatic closing, to guarantee always maximum safety, both for checks and maintenance.